Skip to content

Grumpy Jr – Getting Started

Follow these instructions to install the batteries and configure your Grumpy Jr repeater using the MeshCore Companion app.

Initial Setup

Step 1 – Prepare Your MeshCore Companion

Before beginning, make sure your MeshCore Companion is powered on and synced with your phone.

Step 2 – Remove the Rear Panel

Using the provided T20 wrench, remove the T20 bolts securing the rear panel of the repeater. Carefully remove the back plate.

Step 3 – Install the Batteries

Insert both 21700 lithium batteries into the battery compartment, making sure they are properly seated.

Step 4 – Locate Your Grumpy Mesh Repeater

Watch the Contacts list in your MeshCore app for a repeater named:

Grumpymesh Repeater XXXX

The XXXX represents your order number.

Note: If you ordered more than one repeater, each repeater will use the same order number followed by a sequential letter (A, B, C, D, etc.) to identify each individual unit.

Step 5 – Connect to Your Grumpy Mesh Repeater

Once you see your repeater in the Contacts list, select its name.

When prompted for a password, enter:

  • Admin Password: Admin
  • Guest Password: hello

Keep the Guest password handy for future use.

Step 6 – Rename Your Repeater

Once connected, navigate to Settings in the MeshCore app. Find the repeater name setting and rename it to whatever name you prefer.

Step 7 – Confirm Your Repeater Radio Settings

Verify that your repeater's radio settings are correct for your area.

If you provided a location during your order and the appropriate regional settings could be identified, your repeater should already be configured.

The preset will be labeled either US or Canada. Both presets use the same settings.

  • Default: SF 7 / CR 5
  • Extended range: SF 7 / CR 8

Range tip: If your repeater is far from other repeaters, use CR 8 for the best range.

Step 8 – Set Advert Intervals

Confirm the advert intervals for your region.

Current defaults:

  • Local: 240 minutes
  • Flood: 23 hours

Change these settings to match your local mesh group's recommendations.

Step 9 – Set Your Repeater Location

In the Location section, enter the location where your repeater is installed. You can also use the map icon to choose an approximate location.

Privacy tip: If you do not want to show the exact location of your repeater, it is okay to choose a place one or two blocks away.

Step 10 – Save Your Repeater Settings

Once you have confirmed your repeater name, radio settings, advert intervals, and location, press Save to apply your changes.

Step 11 – Manage Regional Codes (If Applicable)

If your region has started using MeshCore Region Codes, open Manage Regions.

Here you can confirm any region codes that may already have been entered and add any additional region codes used in your area.

When finished:

  1. Press the check mark at the top of the screen.
  2. Press Reboot to restart your repeater and apply the changes.

Step 12 – You're Ready to Go!

Congratulations! Your Grumpy Jr repeater is now configured and ready for use.

Alternative Setup Using USB-C

If your repeater does not advertise its name or appear in your MeshCore app's Contacts list, you can configure it using the USB-C port located on the bottom of the repeater.

  1. Connect the repeater to your computer using the USB-C port.
  2. Visit the MeshCore Flasher website.
  3. Open the Repeater Setup program.
  4. Select your repeater and configure it using the same options outlined above, including your repeater name, location, radio settings, advert intervals, and regional codes.
  5. Save your settings and reboot the repeater.